User's Manual

C007964_04_CR2600_User_Manual

14.0 - Reading Ranges

CR2600 Performance

Test Code Min Inches (mm) Max Inches (mm)

3 mil Code 39 3.1” (80 mm) 4.0” (102 mm)

7.5 mil Code 39 1.3” (33 mm) 7.2” (182 mm)

10.5 mil GS1 DataBar

0.8” (20 mm)

8.7” (220 mm)

13 mil UPC 1.1”(28 mm) 11.0” (280 mm)

4.2 mil Data Matrix 1.9” (48 mm) 4.3” (110 mm)

5 mil Data Matrix 1.7” (43 mm) 4.5” (115 mm)

6.3 mil Data Matrix 1.3” (33 mm) 5.9” (150 mm)

10 mil Data Matrix 0.8” (20 mm) 7.1” (180 mm)

20.8 mil Data Matrix 1.1” (28 mm) 13.5” (343 mm)

Note: working ranges are a combinaon of both the wide and high density elds. All samples were high quality codes

and were read along a physical center line at a 10° angle. Default AGC sengs were used. Accuracy= +/- 10%.

Important Note If Using a non-Code Bluetooth Device:

To connect to a Bluetooth device not manufactured by Code, you will need the Bluetooth address (oen referred to as the BD_ADDR)

of that device. The 12-character Bluetooth address can be found on the device near the serial number. Then visit Code’s website at:

hp://www.codecorp.com/bdaddr.php and enter the 12-character address to create the QuickConnect Code.

You will need to locate the Communicaons (COM) Port assigned to the Bluetooth serial port protocol before installing the Bluetooth

Conguraon Manager soware that is included with your Bluetooth adapter (e.g., COM 10). This is the COM Port through which the

CR2600 will connect.

QuickConnect Code

Blue LED

Wireless

Icon

Storage Icon

Good Read

Indicator

Communicaon

Mode Switch

Figure 19 Figure 20

Figure 21 Figure 22

13.0 - Establishing a Bluetooth® Connecon

1. If establishing a Bluetooth connecon using the Charging Staon with embedded CodeXML® Modem, slide the Communicaon

Mode Switch on the Charger/Modem Staon (Figure 19), to Bluetooth mode (the direcon of the arrow).

2. Scan the QuickConnect Code located on the front of the Charging Staon with embedded CodeXML® modem or on the external

CodeXML® M3 Modem (Figures 20 and 21).

3. The wireless icon located at the top of the reader will ash as it aempts to make connecon (FIgure 22). The blue LED on the

charging staon or CodeXML® M3 Modem (Figures 20 and 21) will also ash as it aempts to connect. The blue LED will turn

solid when connecon is established, the CR2600 will beep once and the wireless icon will ash every 10 seconds.

For additonal CodeXML® M3 Modem conguraon informaon, please reference the CodeXML® M3 Modem QuickStart Guide.