User's Manual

D013597_1.0_CR3600_User_Manual
1.0 - Unpacking
Remove the CR3600 from its packing and inspect it for damage. If the reader was damaged during shipping, please call Code at
[phone].
1
Based on the kit purchased, a combinaon of the following components will be included with the CR3600:
Charging Staon with
Embedded CodeXML® Modem
Charging Staon
USB Cable
Power SupplyCodeXML® M3 Modem
with USB or RS232 cable
Baery
Weighted
Base Plate
Screws
Rubber Feet
2.0 - Charging Staon Assembly Instrucons
1. Plug the barrel side of the USB charge cable or power supply (depending on which you ordered) into the charger. (Figure 2)
2. (Oponal) Aach the weighted base. Place the ‘This Side Down’ (Figure 3) side of the weighted base onto the surface, and place the
Charging Staon on top of it. (Figure 1) and secure with the screws provided. (Figure 4)
Figure 2
Figure 3
Figure 4
3. Rubber feet can be placed on the corners of the weighted base (Figure 5) or directly onto the Charging Staon (Figure 6) to
prevent slipping from a surface.
4. (Oponal) Mounng the Charging Staon to a Surface. Place the ‘This Side Down’ (Figure 3) side of the weighted base onto the
surface, and secure with screws. Note: Because surface types dier, screws are not included to mount a Charging Staon to a
surface.
5. Place the Charging Staon on top of the weighted base (Figure 1) and secure the Charging Staon to the base with the screws
provided (Figure 4)
Note: The weighted base has the same pre-drilled mounng holes as the ECS-H and UMC Chargers.
Figure 5
Figure 6