User's Manual

Using the Remote Engine Start Function (continued)
Pre-Heating or Pre-Cooling the Interior of the Vehicle:
Before exiting the vehicle, set the temperature controls to the desired setting and operation. After the system starts the vehicle, the heater or air-
conditioning will activate and heat or cool the interior to your setting.
Service Mode:
In service mode, the remote start function is temporarily disabled to prevent the system from unexpectedly starting the engine while being
serviced.
To engage or disengage service mode:
1. Enter the vehicle and close all vehicle doors and trunk/rear gate.
2. Verify that the transmission shifter is in the “park” position.
3. Depress and hold the vehicle’s brake pedal.
4. Turn the ignition key to the “on” position.
5. Press and release the remote start transmitter “ “ button three (3) times. The system will honk the vehicle’s horn each time the
button is pressed.
6. The system will pause for 1 second then honk the vehicle’s horn three (3) times to indicate that service mode has been engaged or
honk one (1) time to indicate that service mode has been disengaged.
NOTE
When taking your vehicle in for service, it is recommended that you inform the service personnel that your vehicle is equipped with a remote
engine start system.
Remote Transmitter Programming:
New transmitters can be programmed to the remote engine start system in the event that a transmitter is lost, stolen, damaged or additional
transmitters are desired (the system will accept up to eight (8) transmitters). Remote engine start transmitters can be programmed using the
following procedure.
1. Open the driver’s door (the driver’s door must remain opened throughout the entire process).
2. Turn the ignition to the “on” then “off”, “on” then “off”, then back on and leave on throughout the programming process.
3. The system will flash the parking lights and honk the horn three (3) times, indicating that the system has entered transmitter learn mode.
4. Press and release the “ “ button on the transmitter you wish to program.
5. The system will flash the parking lights and honk the horn one (1) time, indicating that the system has learned the transmitter. Upon
successful programming, the remote start confirming transmitter button will flash one (1) time
6. Repeat step four (4) for any additional transmitters (the system will accept up to eight (8) transmitters).
7. The system will exit transmitter learn mode if the ignition key is turned to the OFF position, the door is closed or after two (2) minutes.
55
55
5