User's Manual

5
Using Your Remote Transmitter (cont.)
Disabling the IT-s
TM
Interior Theft Sensor
It may be necessary at times to disable the IT-s
TM
Interior Theft Sensor,
especially when parking in areas (like parking garages) where extreme
vibration may cause false alarms. Press the ARM button and then press
the FIND/PANIC button within two seconds of pressing ARM to disable
the interior theft sensor. The siren will chirp three times to indicate that
the sensor is disabled. The sensor will become enabled again the
next time the system is armed normally.
Two-Stage Door Unlock
If this feature is enabled on your system, pressing DISARM one time
will unlock only the driver’s door. Press DISARM again within 1 minute
to unlock all doors.
Activating the Trunk Release Feature
Press and hold TRUNK to open the vehicle trunk or hatch (if equipped
and connected). If this button is used to operate another accessory,
the accessory will stay active for as long as the button is held.
Personal Protection Alarm (Panic)
Press and hold the PANIC button to activate the vehicle horn and
parking lights for 30 seconds. Press any remote control button to turn
off the Panic alarm.
Using Second Car Mode
If this feature is enabled, one transmitter will control two vehicles equipped
with a Power Elite
TM
system. To operate the second vehicle, press the shift
button, then within two seconds, press the desired function button.
Using Valet Mode
If the Passive Arming feature is enabled on your system, Valet mode
temporarily prevents the alarm system from arming automatically.
This is useful when fueling or servicing your vehicle.
To enter Valet Mode:
With the vehicle ignition on, press the ARM button. The red dashboard
warning light (status indicator) will turn on for one second, then turn
off. This indicates that the system is in Valet mode. Once the ignition is
turned off, the status indicator will emit a quick double-flash pattern.
Note: In Valet mode, all keyless entry, convenience and remote start
features operate normally.
To exit Valet Mode:
With the vehicle ignition on, press the DISARM button. The red
dashboard warning light (status indicator) will turn on for one second,
then turn off. This indicates that the system has exited Valet mode.
Hint: To prevent your security system from automatically arming while
unloading or refueling your vehicle, without placing the system in
Valet mode, simply press the disarm button on your remote control
transmitter after turning the ignition key off. Doing so places your
system into a temporary or onetime Valet mode. Next time you exit
your vehicle the system will arm in the normal manner.