User's Manual

MAY/26/02003
RST762R OP
8
ACTIVE ANTI CAR JACKING:
1. Press and hold the transmitter
and button at the same time for 2 seconds while the vehicle’s
ignition is ON. The parking lights will turn on for 1.5 seconds to indicate this enter.
2. Once the system is armed, If you are forced from the vehicle, the system will trigger when the door is
opened and closed while the ignition is “ON”.
PASSIVE ANTI CAR- JACKING:
It operate as below:
1. Turn the ignition switch to “ON” position, the system will arm.
2. Once the system is armed, If you are forced from the vehicle, the system will trigger when the door is
opened and closed while the ignition is “ON”.
TRIGGER THE ANTI CAR -JACKING MODE:
3-timer circuits will function as follows:
First timer:
a. 50 seconds after the system has beer triggered. The siren will start chirping for 15 seconds.
b. During this 15 seconds period of chirping, you will be alerting to push the valet switch once to turn off
the car-jacking feature.
c. If not, it will enter second timer car jacking.
Second timer:
65 seconds after the system has been triggered. The siren starts alarming and the parking light starts
flashing.
Third timer:
90 seconds after the system has been triggered
a. The siren still alarming and the parking light flashing, and
b. The starter disable will activate to prevent the vehicle from starting.
c. It will remain active until the vehicle's battery power exhausted.
OVERRIDE THE SYSTEM TO TURN OFF ANTI CAR- JACKING:
Turn the ignition switch from OFF to ON, and within 10 seconds push valet switch, the siren will stop and
the system disarmed
Note: If you use password pin code to double protect the vehicle security, you will need to use it to
completely disarm the system.
P. LAST TRIGGER MEMORY RETRIEVAL (For two-way transmitter operation only)
If you are out of range and you want to retrieval last trigger’s memory storage in the 2-way remote control
transmitter. Press the
first, within 3 seconds press the (M) button, with one melody sound and
the last trigger’s memory storage in the transmitter will immediately display on the “Red LED”.
THE ACTION OF THE 2-WAY LED REMOTE CONTROL TRANSMITTER
LED
Hood / Trunk Trigger
LED flash for 60 seconds
Door Trigger
LED flash for 60 seconds
Shock Sensor Trigger
LED flash for 60 seconds
Ignition Trigger
LED flash for 60 seconds
Q. SYSTEM’S STATUS CHECK (For two-way transmitter operation only)
When you want to check the system’s present status through the 2-Way remote control transmitter, Press
the transmitter
button twice, within 3 seconds press the (C) button, with one melody sound and
all the system’s present status will immediately displayed on the LED.
Note: If it has no responds then you are out of range.
THE ACTION OF THE 2-WAY LED REMOTE CONTROL TRANSMITTER
LED
Armed
LED turns on for 5 seconds
Disarmed
LED turns on for 5 seconds
Valet mode
Z LED turns on for 5 seconds
Engine Running
LED Fast flash for 60 seconds