User's Manual

MAY/26/02003
RST762R OP
7
Exit The Valet Mode One “Exit” Melody Sound
Remote Door Lock
Z LED turns on for 2 seconds
1 Chirps
Remote Door Unlock
Z LED turns on for 2 seconds
2 Chirps
L. CAR LOCATOR
Under armed mode, press the
button to active car locator function. The siren will chirp 6 times. The
parking light will flash 12 times, for you to easily locate your car.
THE ACTION OF THE 2-WAY LED REMOTE CONTROL TRANSMITTER
MELODY SOUND
Car Locator One “Activate” Melody Sound
M. PANIC FUNCTION: (See Alarm Feature I - 7 Programming.) Two case emergency.
1. Press and hold the
button for 3 second. The alarm will immediately sound.
2. During panic mode, the normal function of this transmitter button will be suspended. The transmitter
and
buttons can be used to lock and unlock the door (if the option is installed), however once the
button is pressed, the vehicle’s starter disable device, (where installed) will be enable allowing the
vehicle to start.
3. To stop the alarm, press and hold the transmitter
or button on the transmitter again for 3
seconds. Also if any transmitter button other than
or button is pressed and released, the panic
mode will be turned off immediately.
4. If the button is not pressed, the alarm will automatically stop after 30 seconds.
N. TRIGGER THE SYSTEM
When armed, your vehicle is protected as follows:
1. Light impact will trigger the warn-away signal.
2. Heavy impacts / Doors open / Hood open / Trunk open / Turn on the ignition key will trigger the
programmed sequence.
The starter disable relay (if installed) prevents the vehicle’s starter from cranking. The siren, horn, parking
lights, and dome light will turn on to alerting of an intrusion for 30 seconds. Then it will stop and automatic
reset and re-arm. If the one of sensors or detectors still active, the alarm system will sound a maximum of
6 times of 30 seconds cycles.
THE ACTION OF THE 2-WAY LED REMOTE CONTROL TRANSMITTER
LED MELODY SOUND
Hood / Trunk Trigger
LED flash for 60 seconds
“Zone 2” Melody Sound for 15 seconds
Door Trigger
LED flash for 60 seconds
“Zone 3” Melody Sound for 15 seconds
Shock Sensor Trigger
LED flash for 60 seconds
“Zone 4” Melody Sound for 15 seconds
Ignition Trigger
LED flash for 60 seconds
“Zone 5” Melody Sound for 15 seconds
NOISE ABATEMENT CIRCUIT: You system has “Noise Abatement Circuit”. It prevents annoying
repetitive trigger sequences due to faulty door pin switches or environmental condition such as thunder,
jackhammers airport noise, etc.
Here’s how “Noise Abatement Circuit” works: The alarm triggers five times. Each time, the same sensor or
switch is triggering the alarm. “Noise Abatement Circuit” will interpret this pattern of triggers as false alarm.
After the fifth trigger, “Noise Abatement Circuit” ignores, or bypasses, that sensor or switch until the other
sensor or switch is trigger.
“Noise Abatement Circuit” covers doors (Hood/Trunk) differently: If the alarm is triggered by an open door
for six full cycles, the doors will be bypassed until the trigger ceases.
O. ANTI CAR- JACKING
Warning: If you don't need the car jacking function in this alarm system, be sure to set car jacking feature
“OFF”. This system is default setting all car-jacking “OFF”. (See Alarm Feature I
-
6 Programming.)