User's Manual

MAY/26/02003
RST762R OP
12
2. The brake pedal is pressed.
3. The hand brake is released (for Standard Transmission Gear Vehicle)
4. Engine is over-revved. {“Tachometer checking type” only}
5. The pre-programmed run time (5 /10 / 20 / 30 minutes) has elapsed.
6. Press
button twice on the remote transmitter under remote start mode .
7. Move the optional remote start enable toggle switch to OFF position. (If installed)
8. The vehicle refused to start running after {3} unsuccessful attempts.
H. DISABLING THE REMOTE START SYSTEM: (If installed)
This feature allows your system’s remote start unit to be temporarily disabled to prevent the vehicle from
being remote started accidentally. This feature is useful if the vehicle is being serviced or stored in an
enclosed area. To disable the remote start, move the optional remote start enable toggle switch to the
OFF position.
BATTERY REPLACEMENT FOR 2-WAY LED REMOTE TRANSMITTER:
Note: If the system is interfered by stronger radio frequency around, sources of high voltage electric power
or
such Obstacles like tall buildings and so on, the transmission range may get shorter as the system
uses
low out put powered frequency.
BATTERY REPLACEMENT:
A CR2450 3V lithium battery powers the Remote Transmitter.
When the power of the battery weakness, it has three short “bi”
sound and the “Orange LED” pause flash for 5 seconds while
pressing the button of the remote transmitter to remind user need
to replace a new battery.
THE ACTION OF THE 2-WAY LED REMOTE CONTROL
TRANSMITTER (LOW BATTERY)
LED
LED turn on for 5 seconds
MELODY SOUND
Three “Button Beeping” Sound
Note: Press the button two times when the battery
compartment is empty, then insert the new battery.