User's Manual
MAY/26/02003
RST762R OP
10
signal for any time duration from 1 second to 120 seconds. For instance, this timer output may be used to
turn on the headlight, power window or sunroof. (Factory defaults setting at momentary output.)
Y. POWER ON MEMONRY:
This security system is equipped with circuitry that will allow the unit to remember its alarm state if the
power is lost and then reconnected.
REMOTE START OPERATION:
A. TO REMOTE START THE VEHICLE:
When you want to start your vehicle,
1. Press
button twice on the transmitter.
2. The parking light will activate to indicate the remote start received the signal.
3. The engine will start approximately 5 seconds.
4. Once the engine is running, after couple seconds the parking light will turn on again and climate controls
will activate and adjust the vehicles interior temperature to your preset setting.
5. The vehicle will run for 5 to 30 minute cycle and automatically shut down.
NOTE: The Remote Start Unit will not start the vehicle if any one of the following conditions exists:
1. The hood is opened.
2. The brake pedal is pressed.
3. Move the optional remote start enable toggle switch to OFF position. (If installed)
4. The gear selector is in any gear other then “PARK” or “NEUTRAL”
THE ACTION OF THE 2-WAY LED REMOTE CONTROL TRANSMITTER
LED
MELODY SOUND
Activate Remote Start
LED Fast flash for 2 seconds
One “Activate” Melody Sound
Engine Running
LED Fast flash for 60 seconds
“Beep Sound” for 5 seconds
Stop The Remote Start One “Stop” Melody Sound
SAFE START (Child safety mode) (See Start Feature I – 6 Programming.)
Factory defaults setting to press the
button twice on the transmitter to start the vehicle. Programming
this feature to eliminate an accidental remote start, when kids enter this transmitter, it requires:
The user press the transmitter
and buttons at the same time to start the vehicle.
B. ENGINE START MEMORIZING FOR THE VEHICLE WITH STANDARD (MANUAL)
TRANSMISSION GEAR (Cut the VIOLET LOOP WIRE for Standard transmission gear vehicle)
The system senses the neutral transmission gear position automatically and there is no prior set-up
required. The system in the standard transmission vehicle operates as following process when you exit the
vehicle to sense and memorize the neutral transmission gear position. If the vehicles are of automatic
transmission gear, this process is omitted.
1. While engine is running by ignition key, pull up the hand brake and place the transmission gear in the
neutral position.
2. Before turning off the engine, press the
button twice on the transmitter.
-- The LED indicator will flash 3 times to confirm enter.
3. Pull off the “Ignition Key” from the key cylinder.
-- Engine continues running until the pre-programmed time elapsed or shutdown input is received.--
4. Exit from the vehicle and Close all doors.
-- The engine still continues running and it is normal operating process.--
5. Within 1 minute from the time of step 1, press the
button on the transmitter to lock the doors.
6-1. If the engine shuts down immediately and the system is now ready for next remote (or
programmable) engine starts.
6-2. If the engine not shuts down immediately, the system is failed in engine start memorize set up,
repeat above process again.
If the door is opened after above process, the prior memorization for the next remote or programmed
engine start sequence is delete and the function shall not work until you repeat above process again.
Note: If the engine start memorize is set up, the dome light convenience delay function will be temporarily
By-pass.