User's Manual

MAY/23/ 2003
RST771IN
3
H8/5 Black / Red wire – (-) 200mA Timer Control Channel 5 Output ……….………………….…..….……
10
H8/6 Black / Green wire – (-) 200mA Programmable Output …………….….…………….…..………..……
10
Programmable Timer Channel 4 Output – (Factory Default Setting)
Key Sensor By-Pass Output
H8/7 Gray wire – (-) 200mA Channel 3 Output ….…………………………….…………..…………….….. 11
H8/8 Pink wire – (-) 200mA Programmable Output …………………………….……………….……………. 11
2 Steps Unlock Output (Factory default setting)
Factory Security Disarm Signal Output
Start Status (Shock Sensor By-Pass Control) Output ……………….……………..………………. 11
H8/9 Orange / White wire –(-) 200mA Grounded Output When Disarmed ……….………..……………..
11
H8/10 Orange wire – (-) 200mA Grounded Output When Armed ……………….…………..………….……
11
H9. 2 PIN BLUE CONNECTOR FOR THE VALET SWITCH .……………………………… ….………..…….. 12
H10. 2 PIN WHITE CONNECTOR FOR THE LED STATUS INDICATOR ………………….…....…..….…….
12
H6. 3 PIN DOOR LOCK CONNECTOR ………………………..………………………………………..…..……..
12
Install New Door Lock Motors ….…………………………….…………………….……………..…..…..……..
12
Negative Trigger Door Lock System .…………………………….……………………….…………...………..
12
Positive Trigger Door Lock System ….…………………………….…………………….…………….………..
12
Alternating Door Lock System ….………………………………….…………………….……………..………..
12
Vacuum Operate Door Locking System ….…………………………….……………….……………..……….
12
2 Steps Door Unlock Wire Connection For 5 Wires Alternating Door Lock System ….……….….…..……13
2 Steps Door Unlock Wire Connection For Ground Switched Door Lock
System ….………..……….…….13
2 Steps Door Unlock Wire Connection For Positive Switched Door Lock
System ….………..……….……13
PROGRAMMING & TESTING:
A. PROGRAMMING THE REMOTE
TRANSMITTER ………………………………………………………..…...13
B. FEATURES
PROGRAMMING ……..………………………………………………………………………..... …13
Alarm Feature “I” Programming ……………………………………………….………..………..…………..….
14
3 / 30 seconds Delay Door Ajar Error Chirp ………………………………….….………………..…..…...
15
45 second Door By-Pass (With Dome Light Turn On After Ignition Off) …………………..………..…..
15
Alarm Feature “II” Programming ……………………………………………….…………………..………..…..
15
Alarm Feature “III” Programming ……………………………………………….…………………..……….…..
16
Channel 4 (5 / 6) Timer Control Output Programming ………………….…………………...……….…...
16
Key Sensor By-Pass Output Programming ………………….…………………...……………..…….……
17
Password Pin Code Setup ………………………………………………….…………………..……….……
17
Start Feature “I” Programming ……………………………………………….…………………..…………..….
17
Safe Start (Child Safety Mode) ………………………………………………………………..………...…...
18
Start Feature “II” Programming ……………………………………………….…………………..……………..
18