User's Manual

MAY/23/ 2003
RST771IN
15
3 Press and release the transmitter
button corresponding to the feature ‘Arming mode’ you want to
program. [1] LED flash, [1] chirp to indicate you are in features “Active Arming”.
4 Depress the transmitter
button twice to change the feature. [3] LED flash, [3] chirps to indicate your
are in features “Passive Arming with Passive Door Locking ”.
5 Depress the transmitter
button corresponding to the features ”Rearm on/off”’ you want to
program……..
Press
Transmitter
Button
One Chirp /
LED one pulse
Factory Default
Setting
Two Chirps /
LED two pulses
Three Chirps /
LED three pulses
Four Chirps /
LED four pulses
1
All chirps on Siren chirp on only Horn chirp on only All chirps off
2
Active arming Passive arming
without passive door
locking
Passive arming
with passive door
locking.
3
Automatic Rearm
on
Automatic Rearm off
4
3 seconds delay
Door Ajar error
chirp
30 seconds delay
Door Ajar error chirp.
5
+
Without this feature With Dome light turns
on after ignition off
(45 second door
by-pass)
6
+
Without Car-jack
mode
Active Car-jack mode Passive Car-jack
mode
7
+
Panic with Ignition
off
Panic with Ignition on
& off
Panic with Ignition
on & off. Panic
with No time limit.
Without Panic
function.
Exit: Turn Ignition to 'ON' position, or leave it for 15 seconds. A 3 long chirps & 3 parking light flashes to
confirm exit.
3 / 30 seconds Delay Door Ajar Error Chirp:
This feature controls the error chirp that is generated if the system is armed with the door trigger active. This
useful in a vehicle that has a long dome light delays after the door has been closed. If the system is armed
before the dome light has turned off, the security system will generate the door trigger error chirp. Use this
feature to disable the door open error chirp.
With Dome light turns on after ignition off:
Some vehicles turn on the dome light when ignition key is turned off. After remote start, with alarm on, a
false alarm may occur when the run time elapses and the dome light comes on. To prevent this from
happing, program Alarm Feature I – 5 to “With Dome light turns on after ignition off (45 second door
by-pass)”.
ALARM FEATURE “
II
” PRORAMMING:
1 Turn the Ignition switch ‘ON/OFF’ 3 TIMES and stay in OFF position.
2 Push the Valet switch 4 times and hold it until two chirps with a long chirp is hearing then release the
valet
switch. You are now in the Alarm feature ‘II’ programming mode.
3 Press and release the transmitter button ‘A’ corresponding to the feature ‘A’ you want to program.
Press
T
ransmitte
r
Button
One Chirp / LED
one pulse
Factory Default
Setting
Two Chirps / LED
two pulses
Three Chirps / LED
three pulses
Four Chirps / LED
four pulses
1
0.8-second Door
lock pulses.
3.5-second Door
lock pulse.
Double pulse unlock