User's Manual

o override the system:
1. Open the vehicle door. The alarm will sound.
2. Turn the ignition key to the on position.
3. Within 10 seconds, press and release the valet push button switch.
The alarm system will stop sounding and enter the disarmed mode. You can now start and operate the
vehicle normally.
Typically this override mode is used only if the transmitter has become inoperative. You may elect to
enter the VALET mode until repair or replacement of the transmitter, after which, returning the system
to the full operation mode is necessary. To do so, see the heading VALET SWITCH.
ELIMINATION THE NORMAL ARM/DISARM CHIRPS
As explained earlier in the manual, you can eliminate the chirps selectively any time you arm or disarm
the system simply by pressing both transmitter buttons. If you find the normal arming and disarming
chirps annoying, they can be turned off permanently, elimination the need to press both buttons. To
turn chirps off permanently, selectable features # 6 & 7 must be turned off in the feature programming
section of the installation manual. Refer to this manual or consult with your installation technician to
have this feature turned off.
NOTE: Whenever the chirps are bypassed, the 4 chirps intrusion indicator and 3 chirp defective zone
indicator will always operate. Since these are important warnings to you that something has happened,
they cannot be eliminated.
SENSOR DEFEAT FROM THE TRANSMITTER
This system ha the ability to allow the sensor to be defeated, from the transmitter, enrirely for one
arming cycle. To use remote panic,
Arm the system by pressing the arm button of the transmitter one time.
If within 3 seconds of arming the system you press the arm button a second time, the sensor will be
defeated for one arming cycle. If the system emits two chirps, you waited too long and inadvertently
disarmed the system.
REMOTE PANIC OPOERATION
The ARM or DISARM button on your keychain transmitter also functions as a panic switch for use in
emergency situations. To use remote panic,
1. Press and hold the ARM or DISARM button on the keychain transmitter for 3 or more
seconds. The alarm will immediately sound.
2. To stop the alarm, press and hold the ARM or DISARM button on the transmitter again for
3 seconds. If the button is not pressed, the alarm will automatically stop
After 30 seconds.
ADDITIOAL REMOTE FUNCTION (CHANNEL 2)
This security system has an additional feature that can be connected to a number of different
Optional accessories. Some of the more common uses for this channel are;
 Remote Trunk Release
 Remote Car Start
 Remote Window Closure
To activate the optional accessory, press and hold button 2 on the keychain transmitter for two
Seconds.
Page 5