User's Manual

 Parking Lights flash two times.
If the parking lights flashed three times, then the alarm was triggered in
your absence. Before turning the key on, examine the LED to identify
Which zone was triggered.
 Siren will not sound.
If the siren sounds 4 chirps, then the alarm was triggered in your absence.
Before turning the key on, examine the LED and refer to the INTRUSION
WARNING SIGNALS section of this manual to identify which zone was
triggered.
 Doors Unlock- optional
Note: Must be selected on during installation.
INTRUSION WARNING SIGNALS
This system will inform you if an intrusion attempt has occurred while you were away from the
Vehicle. If an intrusion attempt has occurred, the siren will chirp 4 times and the parking lights will
Flash 3 times when disarming the system. Enter the vehicle, and observe the red dash mounted LED
To identify which zone was triggered.
If the LED is flashing two times…pause…etc; then an intrusion attempt was made to
A hood or trunk pin switch that was added to the system, or to a light activated entry
Point if the alarm was installed using the voltage sensing feature.
If the LED is flashing four times…pause…three times…pause…etc; then an intrusion attempt was
made through one of the vehicle’s doors.
If the LED is flashing four times…pause…four times…pause…etc; then the shock sensor was
activated in your absence.
If the LED is flashing five times…pause…five times…pause…etc; then an attempt to start the vehicle
by the ignition switch had occurred din your absence.
These intrusion warning indicators are stored in the system’s memory, and will only be erased when the
ignition key is turned on
VALET SWITCH
The valet switch allows you to temporarily bypass all alarm functions, elimination the need to hand
your transmitter to parking attendants or garage mechanics. When the system is in valet mode, all
alarm functions are bypassed, however the remote panic feature and remote door locks will remain
operational. To use the valet mode, the system must first be disarmed either by using your keychain
transmitter, or by operation the manual override sequence.
1. From the disarmed condition, turn the ignition key to the on position.
2. Press and hold the valet push-button switch until the dash mounted LED, (Light Emitting
Diode) turns on. The LED will remain on as long as the stem is in valet mode.
3. To return to normal operation, turn the ignition switch on, then.
Press and hold the push button switch until the LED turns off.
NOTE: Always remember to return the system to the NON VALET mode, after servicing, to
Ensure that the vehicle remains protected at all times.
MANUALLY OVERRIDING YOU SYSTEM:
USING THE VALET SWITCH MANUAL OVERREDE
Your Security System can be disarmed without the use of the keychain transmitter. This is
Necessary, since you will need the ability to operate your vehicle if the transmitter is lost or its
Battery fails.
Page 4