User's Manual

ANTI HI-JACK MODE OPERATION
1.a) With the ignition switch on, and the doors closed, press and hold both buttons of the transmitter for
1 second to initiate the antihijack mode. The parking lights will turn on for 1.5 seconds to indicate the
mode was initiated.
b) If while the ignition is on, and a door is opened and then all door is opened and then all doors are
closed, the unit will enter the antihijack mode. The parking lights will turn on for 1.5 seconds to
indicate the mode was initiated.
2. a) 60 seconds after initiation, the siren will begin to sound and the parking lights will begin to flash.
b) 120 seconds after initiation, the siren will start to sound, and the parking lights will begin to flash.
3.a) 90 seconds after initiation, the starter inhibit circuit,(when installed) will be activated, the siren and
lights will continue until the battery is exhausted, or until the unit is reset.
b) 150 seconds after initiation, the starter inhibit circuit, (when installed), will be activated, the siren
and lights will continue until the battery is exhausted, or until the unit is reset.
NOTE: If you are the unfortunate victim of a vehicle Hi-Jack, for your personal safety, it is best to
leave the vehicle as quickly as possible. Never attempt to oppose the thief in any way. If the thief
prevents you from leaving the vehicle, disarm the Hi-Jack feature to prevent the system from sounding
while you are in the presence of your captor. Once you exit the vehicle, opening and then closing the
door will initiate the Hijack feature the system will go through the cycle mentioned above. Once the
engine is turned off, it cannot be restarted if the optional starter inhibit Circuit is install. The unit will
continue to make noise from the siren or the form and the lights will continue to flash until the system
is reset, or until the battery is exhausted.
DISARMING THE HI-JACK FEATURE
Anytime after the HI-Jack mode has been triggered, the circuit can be disarmed simply by pressing the
hidden push button switch. Depressing this switch one time will cause the security to reset the
HI-JACK mode. The circuit will not trigger again unless the door is opened and then closed while the
vehicle is running.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.
CAUTION: Changes or modifications not expressly approved by the manufacturer responsible
for compliance could void the user’s authority to operate the equipment.
Page 6