User manual

20
Printable character only- If this option is selected, the scanner will output the printable characters only,
i.e. in ASCII from 20H to 7EH.
Alphanumeric character only- If this option is selected, the scanner will output the alphanumeric
characters only, i.e. “A”-“Z”, “a”-“z”, “0”-“9”.
Decoder optimization: If it is enabled, the scanner will optimize the decoder with error correction. This
function is not effective for all types of barcodes.
Data output delay in continue-scan mode: If it is enabled, in the continue-scan mode, the scanner can
store the data while continue-scanning. The scanner will output the data after the predefined delay
elapsed. The maximum storage of data is 1000 characters. If this parameter is set to be “00”, the
scanner will not store data. And if the parameter is set to be “FF”, the scanner will output data after
stopping scanning.
Multiple-scan setting
Option bar code Option Alpha. entry
Single-scan setting
Good-read off 00
Momentary 01*
*
Alternate continue 02
Continue 03
Scanning mode
Timeout off 04
01-99
Standby duration
01-99 (second)
04*
00-FF
16
Same barcode delay time
00-FF
16
(50ms)
08*
00-09
Double confirm
00-09
(00: no )
00*
*
04-99
Global max. code length for 1D
symbology
04-99
99*
*
01-99
Global min. code length for 1D
symbology
01-99
04*
*