User manual

Hand-held scan & some global settings

Scanning mode:

Good-read off-The trigger button must be pressed once to activate scanning. The light source of

scanner stops scanning when there is a successful reading or no code is decoded after the Stand-by

duration elapsed.

Momentary-The trigger button acts as a switch. Press button to activate scanning and release button to

stop scanning. The light source of scanner stops scanning when there is a successful reading or no

code is decoded after the Stand-by duration elapsed.

Alternate continue-The trigger button acts as a toggle switch. Press button to activate or stop scanning.

Continue-The scanner always keeps scanning, and it does not matter when the trigger button is pressed

or duration is elapsed.

Timeout off-The trigger button must be pressed once to activate scanning. The light source of scanner

stops scanning when no code is successful decoded after the Stand-by duration elapsed.

Same barcode delay time: If a barcode has been scanned and output once successfully, the laser beam

must be off or moved away from the barcode beyond delay time to active scanning the same barcode.

When this feature is set to be “0xFF”, then the delay time is indefinite.

Double confirm: If it is enabled, the scanner will require a several times of same-decoded-data to confirm

a valid reading.

Global Max./Min. code length for 1D symbology: These two lengths are defined as the valid range of

decoded 1D barcode data length. Make sure that the minimum length setting is no greater than the

maximum length setting, or otherwise the labels of the symbology will not be readable. In particular, the

same value can be set for both minimum and maximum reading length to force the fixed length barcode

decoded.

Notes:

1. Please set the max./min. length for individual barcode in later sections, if special demand is

requested.

2. The number of check digits is included in max./min. code length.

3. These two settings have no effect on the symbologies with fixed-length, e.g. UPC-A, UPC-E, EAN-13,

EAN-8 and China Post.

Global G1-G6 string selection: The scanner offer one or two string group for ALL symbologies. By

setting one or two digits to indicate which string group you want to apply. You may refer to the chapters

of “String setting” and “String position & Number of truncated leading/ending character”.

Example: Group 1 → set 01 or 10. Group 2 and 4 → set 24 or 42.

All valid settings include 00, 01, 02, 03, 04, 05, 06, 10, 11, 12, 13, 14, 15, 16, 20, 21, 22, 23, 24, 25, 26,

30, 31, 32, 33, 34, 35, 36, 40, 41, 42, 43, 44, 45, 46, 50, 51, 52, 53, 54, 55, 56, 60, 61, 62, 63, 64, 65 and

66.

Element amendment: If it is enabled, the scanner can read the barcode comprised with bars and spaces

in different scale.

Character output restraint: