Owner`s manual

An illustration showing the proper electrical connections for 240 volt service has been
provided for you on a wiring diagram and conversion instruction affixed to the backside
of the electrical box faceplate. GFCI wiring instructions you can find on the backside of
the electrical box too. Be sure to follow these and all other instructions carefully. Be
sure that all connections are tight before switching on the circuit breaker.
CAUTION! Failure to abide by specification listed may result in damage to equipment
and may void the warranty. IF THE SPA IS WIRED INCORRECTLY, YOUR
WARRANTY WILL BE VOID ON ANY BURNED OUT ELECTRICAL
EQUIPMENT.
G.F.C.I Line-out Wiring Check for 120/240V convertible System (3/4 wire system
including ground wire).
If the spa is equipped with a 120/240V control system, an additional white load neutral
wire must connect to the load neutral out. This wire runs with the others to the system
box. Proper placement of this neutral wire is essential. If miss-wired, the G.F.C.I will
trip.
G.F.C.I (Ground Fault Circuit Interrupter)
IMPORTANT
This service must be single phase. Do not attempt to fix these types of problems
yourself. High voltage can seriously injure or kill. Always use a certified electrician
when hooking up your new spa.
The National Electrical Code states that a service disconnect breaker box (a G.F.C.I. can
be used for this purpose) must be located at least 5 feet away from the spa and should be
conveniently located near the equipment bay. If it is not in plain sight, keep the
disconnect padlocked when in the off position.
Remember, high voltage is still accessible in the housebreaker box even though you have
turned off the spa breaker.
CS6200 CONTROL BOX ASSY
Control Box
Heater Assembly
Pump Assembly
9