Owner`s manual

Restricted Flow - Insure that the water shut-off valves are open and that suction
fittings are not blocked by debris.
Dirty Filter - Clean or replace filter.
Low Water Level - Increase water level to recommended level.
NO LOW SPEED PUMP OPERATION
Low level Programming Incorrect - Contact your local dealer.
Over or High Temperature Protection - Turn power off then back on to reset.
Pump Not Plugged-In - Plug in the Pump.
NO PUMP OR BLOWER OPERATION
Pump or Blower Not Plugged-In - Plug in the Blower or Pump
Over or High Temperature Protection On - Turn power off then back on to reset.
NO THERAPY JET OPERATION
Water Shut-Off Valves are Closed - Open Shut-Off Valves.
Dirty Filter - Clean or Replace Filter
Jets Not Properly Adjusted - Adjust Jets properly.
Diverter Valve not Properly Adjusted - Adjust diverter valve properly.
Thermal Overload Tripping - Check for restricted flow of water.
Over or High Temperature Protection On - Turn power off then back on to reset.
WATER LEAKS
Spa Overfilled - Adjust water level.
Too Many People in the spa - Adjust water level.
Drain - Valve left Open - Close drain valve.
Coupling or Unions Loose - Tighten or contact your local dealer.
Pump Seal Leaking - Contact your local dealer.
Plump Seal leaking - Contact your local dealer.
Plumbing / Connection Leaking - Contact your local dealer.
Water Leaking from Spaside Control - Contact your local dealer.
Water in Air Blower Plumbing - Contact your local dealer.
NO HEAT
Temperature Not Set Correctly - Adjust Set Point.
Over or High Temperature Protection On - Turn power off then back on to reset.
Current Limiting On - 120V Systems will not heat if High Speed or Blower is on.
Contact your local dealer.
No Power - Reset breaker at service panel.
Low Water Flow - Clean or Replace Filter.
HIGH HEAT
Temperature Sensor Not in Dry-Well - Place sensor in dry-well.
Temperature Set Too High - Adjust Set Point.
High Ambient Temperature - Remove spa cover.
23