Owner`s manual

increase or reduce the pH gradually to ensure damage does occur to your spa or
equipment. Add chlorine/bromine into the water in the method your have chosen.
NOTE! If a tablet of chlorine/bromine is used, “shock” the water first with the spa
shock. Add the Water Clarifier and Stain & Scale chemicals as recommended on the
chemical bottle.
CHEMICAL TROUBLE SHOOTING GUIDE
Just as with anything else, adjusting and balancing spa chemicals takes practice. Below
are a number of common problems, which may arise in your spa water. Try curing the
problem by following the trouble-shooting guide. If the problem persists, or the problem
is not covered in the following guide contact your authorized After Hours Dealer.
PROBLEM SOLUTION
Cloudy Water
1. Cloudy water is normally due to high
pH or low chlorine/bromine levels. Test
the water and correct the pH levels and
chlorine/bromine levels.
2. Excessive use of defoamer chemical
may cause the water to turn cloudy.
Foamy Water Use defoamer in the water. This chemical
must be used only when necessary. It will
cause the water to turn cloudy if used
excessively.
Green or Yellow Water This usually means the water is low on
chlorine/bromine levels. “Shock” the water
and test for chlorine/bromine levels. Add
water clarifier.
Scum Line A scum line will normally appear on the
water level of the spa. However, it us
unusual for scum line to persist. Ad stain
and remover as directed.
TOP SIDE ERROR IDENTIFICATION
104
Three Flashing Dots with Pump Off
Pressure or Flow Switch Activated: If 3 flashing dots appear below the temperature
display while there is no pump operating, turn the pump on. If the 3 flashing dots went
away this indicates that the pressure or flow switch was activated although there was no
water flow. (Contact Your Local Dealer for Service)
21