Owner`s manual

oxidize organics, and control minerals. Anytime the pump, the air blower, or the light is

turned on, the ozone will turn off.

OZONE GENERATOR SAFETY INSTRUCTIONS – OPTIONAL

 Do not add any device that could, or attempt in anyway to, interrupt the flow of

ozone to spa water.

 Do not allow ozone level to reach or exceed 0.1 PPM.

 Do not attempt to energize ozone generator with ozonator’s cover off.

 The internal lamp in the ozone generator is intended for application only where

humans will not be exposed to the ultraviolet radiation produced.

 Do not block ozone jets or could cause damage to ozonator and void warranty.

FILTER ASSEMBLIES AND PARTS

Spa Model Filter Size Part#

Siesta, Venice, Monte Carlo 35 Sq. Ft. 2741 2ea,

San Marco 50 Sq. Ft. 5532

The filter(s) in your spa should be cleaned at least every 5-6 weeks, depending on usage.

This will ensure that the water is being filtered properly, and there is no restriction in the

filter due to dirt and grease.

Cleaning the filter can be done easily using a Filter Degreaser solution and following the

directions on the bottle. Soak filters in a degreaser and power wash with a garden hose. It

is recommended to have a second filter, which can be cleaned between changes. This

will enable you to quickly exchange the dirty filter with the clean one and immediately

start your spa again.

Lid

Basket

Diverter

Plate

Filter

Cartridge

Adjusting Diverter Plate: In the event that air is being drawn

into the skimmer, it may be necessary to adjust the diverter

plate (slow the water flow). This is done by turning knob “A”

thereby adjusting opening “B”. Turn clockwise to increase and

counter clockwise to decrease water flow.