Owner`s manual

DRAINING YOUR SPA
 Turn Power Off .
 Remove Drain Valve Safety Cap – Attach a standard garden hose to drain valve.
 Select A Safe Suitable Drain – Route hose to a sewer drain capable of safely
assimilating 300 plus gallons of water, which may contain both unsanitary
contaminants and chemical residue. Open drain valve.
WARRANTY – Do Not Supply Power To An Empty Spa! - This could damage your
electrical equipment and pumps, voiding warranty.
Remove any remaining water with a shop-vac, sponge and pail, or simply dilute in your
fresh fill. Do not forget to close the drain connection before refilling.
Cleaning the Spa Interior
 To preserve the sheen of your tub’s surface, it is crucial that you void using
abrasive cleaners or cleaners which have adverse chemical effect on the surface.
See your authorized Hydro Spa Dealer
Pillow Care
 Remove and clean the headrest pillows as needed with soapy water using a cloth
or soft-bristle brush. To maintain water resistance and luster, apply a quality
vinyl conditioner once a month.
 Always remove the pillows when adding chemical shock treatment to the tub
water.
 The pillows can be returned to the tub when the sanitizer reading drops below 5
ppm.
OPERATING TOP SIDE CONTROL
Au
Ke
Jets
x
y
Temperature Set Key
Heater On
Filter Cycle
Aux
Jets Key
Display
Temp Set Poi nt
Light
Key
Default System Operation: When power is applied, or there is a temporary loss of power,
the system will initiate its default programming. The filter cycle will begin24-hours after
the system has been powered up. The filtration cycle will be active for 1-hour and will
repeat every 12-hours. The temperature will be maintained at 95
o
F. NOTE: Default
Setting can be changed without notice.
13