Owner`s manual

Light Key: Press this key to turn the light on. A Second press will turn the Light off. The light will automatically shut off
after 2 hours. The Light icon will appear while the light is on.
Temperature Set Keys: Press the Up Arrow key to increase the desired temperature. Press the Down Arrow keys to
decrease the temperature. The temperature can be adjusted in 1 degree F increments from 59 degree F to 104 degree F (5 degree C to
40 degree C). The new setting will remain on the display for 5 seconds as a confirmation. During this time the Set Point icon will be
appear to let you know this is the desired and not the actual temperature. After 5 seconds the display will return to the current
temperature reading. When the temperature drops to 1 degree F below the set temperature, the heater will be turned on until the
temperature is 1 degree F above the set temperature. The heater icon will appear while the heater is on and flash when there is a call
for heat and the heater has not yet been activated.
START-UP INSTRUCTIONS
10
Blower Key (if equipped). Press this key to turn blower on. A second press will turn blower off. Blower will run for 20
minutes once you press the blower key unless you turn it off by pressing the blower key a second time. Blower can be used to cool
the spa.
Default System Operation: When power is applied, or if there is a temporary loss of power, the system will initiate its default
programming. The filter cycle will begin 24-hours after the system has been powered up. The filtration cycle will be active for 2-
hours and will repeat every 12-hours. The temperature will be maintained at 100 degrees F. (Default setting can change) with or
without notice.
Pump 1 Key (Jets 1): Press this key once to turn Pump 1 onto Low Speed, press this key a second time to turn Pump 1 onto
High Speed, a third press will turn the Pump off. A built-in timer will shut the pump off after 20 minutes of operation unless done so
manually. The Pump 1 indicator wil illuminate while the pump is running. If the filter cycle indicator is illuminated, a filtration cycle
has begun and you will not be able to turn the pump off.
If Equipped with Blower:
Press this key to turn the blower on. A second press will turn blower off. Blower will run for 20 minutes once you press the blower
key unless you turn it off by pressing the blower key a second time. Blower can be used to cool water in spa.
Light Key: Press this key to turn the Light on and off. The light will automatically shut off after 2 hours.
Temperature Set Keys: Press the Temperature Set Key Up/Down to increase the desired temperature. Press the
Temperature Set Key Up/Down to decrease the temperature. The temperature can be adjusted in 1 degree F increments from 59
degrees F to 104 degrees F (5 degrees C to 40 degrees C). The new setting will remain on the display for 5 seconds as a confirmation.
During this time the Temperature Program indicator will illuminate to let you know this is the desired and not the actual temperature.
After 5 seconds the display will return to the current temperature reading. When the temperature drops to 1 degree F below the set
temperature, the heater will be turned on until the temperature is 1 degree F above the set temperature. The heater On indicator will
illuminate while the heater is on and flash when there is a call for heat and the heater has not yet been activated.
TOP SIDE CONTROL BUTTONS
CS6200 (Model 510)
Pump 1
Temp Set Point
Filter Cycle
Heater On
Temp Set Key
Adjust Down/UP
Aux
Light
OPERATION