Owner`s manual

Safety Check

Open the cabinet access door panel and check all pump unions to make sure they are hand tight. Loosening can occur during shipping

and handling. Check Shut-Off Valves and insure both are open fully, otherwise your pumps will not function.

Turn on Power

Turn on power to spa at the circuit breaker box. The heater and pump 1 (low speed) will automatically activate.

Initiating Water Circulation

Depress JETS 1 topside pad on the control panel once to activate pump #1 in high speed and initiate maximum water flow to certain

jets.

Depress Aux and Blower Pads on the control panel to activate pumps 2 and blower. Refer to general guidance instructions.

Add Start-Up Chemicals

Add the spa water chemicals as recommended by your spa dealer.

Place Cover On Spa

Keep the insulating cover in place anytime the spa is not in use. Covering the spa will reduce the time required for heating, thereby

minimizing operating cost. The time required for initial heat-up will vary depending on the starting water temperature and the

capacity of your spa. Smaller spas heat at a rate of approximately 8 to 10 degrees per hour; larger spas heat at about 4 to 6 degrees per

hour. Lock the cover with safety locks when not in use.

WARNING: RISK OF INJURY. Always check water temperature carefully before entering spa.

Control Panel

The spa is equipped with a main control panel located on the side of the spa as show above (Figure 6).

The main control panel controls all of the spa functions, and uses indicator lights and an integrated LED display to aid in determining

the status of the spa

Default System Operations: When power is applied, or if there is a temporary loss of power, the system will initiate its default

programming. The filter cycle will begin 24-hous after the system has been powered. The filtration cycle will be active for 2-hour

and will repeat every 12-hours The temperature will be maintained at 100 degrees F.

Pump 1 Jets 1: Press this key once to turn Pump 1 onto low speed, press this key a second time to turn Pump 1 onto high

speed, a third press will turn the pump off. A built-in timer will shut the pump off after 20 minutes of operation unless done so

manually. The Pump 1 icon will appear on the display while the pump is running in high speed and flash while it is in low speed. If

the filter icon appears, a filtration cycle has begun and you will not be able to turn the pump off.

Pump 2 Jets 2 (if equipped): Press this key once to turn Pump 2 on. A second press will turn it off. A built-in timer will shut

the pump off after 20 minutes of operation unless done so manually. The Pump 2 icon will appear while the pump is running in high

speed.

START-UP INSTRUCTIONS

Control Panel Display

Main Control Panel

Figure 6

Manufacturer Of Quality Spas

Jets 1

Aux

Light

Down

Engineered With Visual Illumination

Visual Diagnostic System

Blower

CS6230