User manual

ManualsBrandsCODE MERCENARIES ManualsDev KitsPower supply module LED-Warrior11-MOD

Code Mercenaries

1. Features

• Power supply for DALI bus

• 24 V DC input

• Current limited output, typ. 230 mA

• Bus status LED

• Short circuit tolerant

• Available as PCB module or DIN rail module

1.1 Variants

LED-Warrior11 is available as a bare PCB module

or in a DIN rail mountable enclosure

1.2 LW11-MOD

The LW11-MOD is a ready to use module for low

cost applications where the unit can be mounted in-

side of an enclosure.

1.3 LW11-DR

The LW11-DR is a DIN rail mountable unit that

has internal protection against reversed input volta-

ge and a fuse for safe shutdown in case of a failure.

2. Functional overview

LED-Warrior11 converts 24 V DC into the current

limited power supply for a DALI bus.

By using the easily available 24 V DC as input it

reduces the cost for the power supply significantly

compared to standard solutions.

3. External Connections

LW11-MOD

LW11-DR

+24 V

Positive power supply input. Connect a stabilized

24 V DC source here.

0V / -

Supply voltage negative input.

DALI+ / DALI-

Bus power outputs. Connect the DALI bus here.

Polarity is for information only. Normally it does

not need to be observed on the DALI bus.

DALI devices should be polarity independent and

there must be only a single DALI power supply

connected to a DALI bus.

V1.0.0 October 20th 2015

Power Supply for DALI Bus

Summary of content (4 pages)

PAGE 1
LED-Warrior11 Power Supply for DALI Bus Code Mercenaries 1. Features • Power supply for DALI bus • 24 V DC input • Current limited output, typ. 230 mA • Bus status LED • Short circuit tolerant • Available as PCB module or DIN rail module 3. External Connections 1.1 Variants LED-Warrior11 is available as a bare PCB module or in a DIN rail mountable enclosure 1.2 LW11-MOD The LW11-MOD is a ready to use module for low cost applications where the unit can be mounted inside of an enclosure. 1.
PAGE 2
LED-Warrior11 Code Mercenaries 3.1 Mechanical dimensions (LW11-MOD) Dimensions in mm Height at thickest point: < TBD mm Tolerances: Outer contour: ±0.2mm 3.2 Mechanical dimensions (LW11-DR) 36 x 90 x 56 mm (98 mm total including the rail mounting clips). V1.0.
PAGE 3
LED-Warrior11 Code Mercenaries 4. Absolute maximum ratings Supply voltage (Vcc relative to GND): ....................................................................... -0.5V to +30V Input current: .......................................................................................................................... 500mA Storage temperature: ................................................................................................ -55°C to +100°C ESD: ............................................
PAGE 4
Code Mercenaries LED-Warrior11 5. Ordering information Partname LED-Warrior11-MOD LED-Warrior11-DR Order Code LW11-MOD LW11-DR Package PCB DIN rail 5.1 Packaging info The LW11-MOD modules are packaged bulk in antistatic bags. LW11-DR are packaged individually in cardboard boxes including installation instructions in German and English 5.2 FCC / CE LED-Warrior11-DR is FCC and CE compliant. The LED-Warrior11-MOD is sold as a module to be integrated into a device. As such it can not be FCC or CE approved.