Datasheet

Code Mercenaries

4.2 Dimming by dual button

Two switch up/down dimming sets the output to

last on level on a short press on Up and off on a

short press on Down. Holding Up results in

dimming up and holding Down dims down.

4.3 Setting power on value

The current lamp power value may be stored as the

power-on value. The next time power is applied

LW10 will directly go to the stored power value.

To set the power-on value dim to the desired

brightness, then press and hold any of the buttons

until a double flash of the lamp signals that the

new value has been stored. Storing the brightness

value is triggered if the button remains pressed for

about 5 seconds after the minimum or maximum

value has been reached.

The brightness value that was active before the

button was pressed and held down will be stored.

When the button is released after the double flash

the brightness will be returned to the new stored

value.

4.4 Setting minimum value

Some LED setups will not produce light at the

lower dimming levels of LW10. Especially when

dimming replacement LED lamps this effect can

cause a bad user experience.

A minimum level can be set to which the LED will

go when the Up or Dim button is pressed while the

LED is off. It will also be the lower limit for

dimming down when the LED is on.

Setting the minimum value works similar to setting

the power on value. Dim to the intended minimum

value. Then press and hold any of the buttons. A

double flash will indicate that LW10 has stored the

value as the power on value. Do not release the

button, keep holding it until a second double flash

happens.

Now LW10 has restored the power on value to its

former value and set the min value to the dimming

value that was active before the button was

pressed.

To reset the min value switch the LED off by a

short press on Dim or Down. Then press and hold

any button until the second double flash. This

restores 0.1% as the minimum dimming value.

V1.0.1 January 4th 2016