Data Sheet

Code Mercenaries
2
LL
LL
EE
EE
DD
DD
--
--
WW
WW
aa
aa
rr
rr
rr
rr
ii
ii
oo
oo
rr
rr
00
00
99
99
3.1 Mechanical dimensions (LW09-01/02MOD)
Dimensions in mm
Height at thickest point: ≤ 6.1 mm
Mounting holes: 3.1 mm
Tolerances, outer contour: ±0.2 mm
3.2 Pin Descriptions (LW09-01MOD)
DA
Two lines for the IEC62386 bus, not polarity
sensitive, connect direct to the IEC62386 bus.
SDA
Data line of I2C interface.
High impedance input and open drain output.
SCL
Clock line of I2C interface.
High impedance input and open drain output.
SW0, SW1
Switch inputs for direct lighting control. The
function of these pins can be programmed via I2C.
Factory default setting is for two momentary
switches to control on/off for short action and up/
down dimming for press and hold.
Inputs with internal pull up resistors.
+5V
Positive supply voltage input. +5 V required.
GND
Ground supply voltage.
3.3 Pin Descriptions (LW09-02MOD)
DA
Two lines for the IEC62386 bus, not polarity
sensitive, connect direct to the IEC62386 bus.
SDA
Data line of I2C interface.
High impedance input and open drain output.
SCL
Clock line of I2C interface.
High impedance input and open drain output.
SW0, SW1
Switch inputs for direct lighting control. The
function of these pins can be programmed via I2C.
Factory default setting is for two momentary
switches to control on/off for short action and up/
down dimming for press and hold.
Inputs with internal pull up resistors.
+5V
Positive supply voltage output. Can supply up to
15mA at 5 V to external circuit like RF receiver
modules.
GND
Ground supply voltage.
V1.0.2 December 5th 2019