User manual

LED-Warrior07
PWM-Controller with DALI
LED-Warrior07-01MOD
The LED-Warrior07-01MOD generates a PWM signal to
control LED drivers. LEDs may not be driven direct by
LED-Warrior07-01MOD, an appropriate driver is
necessary.
LED-Wariror07-01MOD can be operated with DC
voltage between 5.5 V and 45 V. AC or the so called
"electronic transformers" may not be used.
None of the signals of LED-Warrior07-01MOD may be
connected to mains voltage!
Connections:
DALI - Connects to the DALI bus, polarity independent
GND - Ground for the power supply
VIN - Positive power supply 5.5 V to 45 V DC
PWM - Positive PWM signal, 0 V = LED off
/PWM - Negative PWM signal, 0 V = LED on
The PWM or /PWM output is used to control a LED driver. Each of the outputs can drive up to 25 mA
to ground and has a 4k7Ω pull up resistor to 5 V which is protected against higher voltages (up to 45 V)
by a diode.
The button is used to assign a DALI address in the "physical select" mode.
LED-Warrior07-02MOD
The LED-Warrior07-02MOD can directly drive constant
voltage LED modules, strips, and lamps.
LED-Wariror07-02MOD can be operated with DC
voltage between 5.5 V and 45 V. AC or the so called
"electronic transformers" may not be used.
None of the signals of LED-Warrior07-02MOD may be
connected to mains voltage!
Connections:
DALI - Connects to the DALI bus, polarity independent
GND - Ground for the power supply
VIN - Positive power supply 5.5 V to 45 V DC
OUT - Output to LED, max. 4 A
The output OUT is connected to the kathode end
(negative) of the LED. The anode end (positive) of the
LED is connected to the positive supply voltage. Only LED modules, strips, or lamps that are designed
to be used with a constant voltage may be used. LED-Warrior07-02MOD can not drive LEDs that
require constant current.
The button is used to assign a DALI address in the "physical select" mode.
DALI is a registered trademark of ZVEI