User manual

Code Mercenaries

4. Implemented DALI commands

LED-Warrior07 implements all

IEC62386-102:2009 commands.

It also implements the relevant commands for type

6 control gear according to IEC62386-207:2009.

Since LED-Warrior07 can not measure the lamp

current, power, or temperature the following

commands have no effect:

Command 224: Reference System Power

Command 225: Enable Current Protector

Command 226: Disable Current Protector

Due to the corresponding functions not being

implemented the following commands always

return a negative answer:

Command 241: Query Failure Status

Command 242: Query Short Circuit

Command 243: Query Open Circuit

Command 244: Query Load Decrease

Command 245: Query Load Increase

Command 246: Query Current Protector Active

Command 247: Query Thermal Shut Down

Command 248: Query Thermal Overload

Command 249: Query Reference Running

Command 250: Query Ref Measurement Fail

Command 251: Query Current Protector Enabled

Command 237: Query Gear Type

Returns DC supply possible, all other flags

negative (=0)

Command 239: Query Possible Operating Modes

Returns PWM possible, all other flags negative

(=0) since the actual implementation of the driver

stage is unknown to the LW07.

Command 240: Query Features

Returns zero flags for all features, except physical

selection, which is supported via the /Select input.

4.1 DALI memory banks

LED-Warrior07 implements DALI memory banks

0 and 1. Both banks use the default length with no

vendor or OEM specific additional information.

Bank 1 can be written by the OEM as defined by

the DALI standard.

V1.1.1 April 22nd 2015