Owner`s manual

Using Your Remote Transmitter

(cont.)

Disabling the IT-s

Interior Theft Sensor

It may be necessary at times to disable the IT-s

Interior Theft Sensor,

especially when parking in areas (like parking garages) where extreme

vibration may cause false alarms. Press the ARM button. Then press the

both buttons within two seconds, to disable the interior theft sensor.

The horn will chirp four times to indicate that the sensor is disabled.

The sensor will become enabled again the next time the system is

armed normally.

Activating the Trunk Release Feature

Press and hold the DISARM button to open the vehicle trunk or hatch

(if equipped and connected). This button is sometimes used to

operate another accessory, the accessory will stay active for as long

as the button is held.

Personal Protection Alarm (Panic)

Press and hold both buttons to activate the vehicle horn and parking

lights for 30 seconds. Press any remote control button to turn off the

Panic alarm.

Using Valet Mode

If the Passive Arming feature is enabled on your system, Valet mode

temporarily prevents the alarm system from arming automatically.

This is useful when fueling or servicing your vehicle.

To enter Valet Mode:

With the vehicle ignition on, press the ARM & DISARM buttons

simultaneously. The red dashboard warning light (status indicator) will

turn on for one second, then turn off. This indicates that the system is

in Valet mode.

Note: In Valet mode, all keyless entry and convenience features

operate normally. (The LED will falsh a double pulse)

To exit Valet Mode:

With the vehicle ignition on, press the ARM & DISARM buttons

simultaneously The red dashboard warning light (status indicator) will

turn on for one second, then turn off. This indicates that the system has

exited Valet mode.

Hint: To prevent your security system from automatically arming while

unloading or refueling your vehicle, without placing the system in

Valet mode, simply press the disarm button on your remote control

transmitter after turning the ignition key off. Doing so places your

system into a temporary or onetime Valet mode. Next time you exit

your vehicle the system will arm in the normal manner.