Owner`s manual

4
* Throughout this manual, ‘press’ refers to pressing for less than 1 second; ‘press and hold’ refers to
pressing for more than 1 second.
**
If you have chosen the Silent Arming Option, the horn will not sound when arming or disarming until the
appropriate button is pressed a second time.
Arming the Security System
To arm the system, exit the vehicle, close all doors, then press* the
ARM button. The horn** will “honk” twice
†
and the parking lights will
flash twice, indicating the system is armed. The doors will also lock at
this time (if equipped and connected). The status indicator (red
warning light on the dash) will blink steadily, once per second.
Pre-arm Mode
If the horn “honks” and the parking lights flash only once, this
indicates that the vehicle courtesy light is on, or that a protected entry
point is not closed securely. Check to see that doors, hood, and trunk
are properly closed. Once all entrances are secured (and the
courtesy light is off), the system will “honk” / flash again. The system is
now fully armed. (If the entrance is not secured within 4 minutes, the
system will arm and ignore the unsecured entrance until it is closed.)
Disarming the Security System
To disarm the system, press the DISARM button. The horn will “honk”
and the parking lights will flash once, and the doors will unlock.
The courtesy light will turn on for 1 minute, or until the vehicle is started.
Attempted Intrusion Identification
If the horn “honks” four times when disarming, this indicates that the
system was triggered in your absence. The status indicator will also
flash rapidly. Perform the following
operation to determine the protected
zone that triggered the system:
After disarming, press the
emergency override button.
The horn will “honk” to indicate
the cause of the alarm trigger:
1 honk IT-s Interior Theft Sensor
2 honks Door
3 honks Hood
4 honks Trunk/Optional Sensors
5 honks Ignition was turned on
Using Your Remote Transmitter
Press both ARM and
DISARM for Find/Panic
Press to DISARM
Security System and
Unlock Doors
Press and HOLD for
TRUNK
Press to ARM the
Security System and
Lock Doors