CPL Remote Security System Owner's Manual FCC COMPLIANCE This device complies with Part 15 of the FCC rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including any interference that may cause undesired operation.
Table of Contents Features and Benefits .............................................................. 3 Using Your Remote Transmitter ........................................... 4-5 Arming the Security System Pre-arm Mode Disarming the Security System Attempted Intrusion Identification Disabling the IT-sTM Interior Theft Sensor Activating the Trunk Release Feature Personal Protection Alarm Using Valet Mode When Your Security System is Triggered ...............................
Features and Benefits Two Easy-to-Use Weather-Resistant Remote Controls The remote controls included with the CPL Security System utilize durable, moisture resistant cases and sealed rubber buttons for reliability and long life. Rolling code technology prevents the transmitter signals from being duplicated. The button functions are clearly labeled to make the system simple to operate.
Using Your Remote Transmitter Press both ARM and DISARM for Find/Panic Press to ARM the Security System and Lock Doors Press to DISARM Security System and Unlock Doors Press and HOLD for TRUNK Arming the Security System To arm the system, exit the vehicle, close all doors, then press* the ARM button. The horn** will “honk” twice† and the parking lights will flash twice, indicating the system is armed. The doors will also lock at this time (if equipped and connected).
Using Your Remote Transmitter (cont.) 5 Disabling the IT-sTM Interior Theft Sensor It may be necessary at times to disable the IT-sTM Interior Theft Sensor, especially when parking in areas (like parking garages) where extreme vibration may cause false alarms. Press the ARM button. Then press the both buttons within two seconds, to disable the interior theft sensor. The horn will chirp four times to indicate that the sensor is disabled.
Automatic Convenience Options The CPL Security System performs a variety of automatic functions to enhance security and comfort. Some of these features are programmable at the time of installation. Please see your installer for further details. Automatic Arming The CPL Security System will arm automatically 1 minute after the ignition is turn off. This feature can be temporarily disabled by placing the system into Valet mode.
System Maintenance Changing the Remote Control Battery The 12-volt alkaline battery supplied in your remote transmitter should last approximately one year, depending on usage. When the battery begins to weaken, you will notice a decrease in range, or the distance from your vehicle that your remote transmitter will operate. Follow the instructions below to change the remote transmitter battery. 1. Using a coin pry off the back of the transmitter (the transmitter snaps together) and expose the battery. 2.
System Maintenance (cont’d) Deleting Lost or Stolen Remote Controls from Your System If one of your remote controls is lost or stolen, follow these instructions IMMEDIATELY to remove the control code from your system. 1. Have all remaining remote controls available. 2. Enter the control programming mode by following steps 1 - 5 of Adding Remote Controls to Your System. 3a.
Emergency Disarm Procedure If your remote control is lost or fails to function, use this procedure to disarm the CPL Security System and start your vehicle. 1. Use the keys to enter the vehicle. The alarm will sound once the door is opened. 2. Insert the key into the ignition and turn to the ON position. 3. Locate and press the emergency override button. The alarm will turn off and then you will be able to start your vehicle. To enter in and out of VALET without a remote transmitter.
Code Systems, Inc. Limited Lifetime Warranty A Code Systems Inc. (“CODE”) vehicle security system sold to a retail consumer purchaser by an authorized dealer of CODE and installed by an authorized dealer of CODE is warranted by CODE to the original retail consumer purchaser to be free from defects in workmanship and materials for the lifetime of the vehicle in which the security system was originally installed.
