Installation guide

Feature Bank 4 - 6 Chirps
1 LED Flash 2 LED flash
3 LED Flash
4 LED Flash 5 LED Flash 6 LED Flash
Remote Start
Control
1 RF.Staft Chirp Ott
OFF
2
Run Time
15 Minutes 5 Minutes
10 Minutes
20 Minutes 45 Minutes 60 Minutes
3
RunnIog Ught8
... Steady
Ft-.l1iog
.'
Tachless Hybrid (Crank
4 Tach Mode
Tach
(Crank Average Average
I NO
DBIPort
I Voltage) Voltage)
5 VoItag8 .Level
"1Qh
low
6 Crank Time 1.0 Seconds 0.8 Seconds
1.5 Seconds
2.0 Seconds
4.0 Seconds
,
--
....
7
Crank' Ave@ging I Crank TIme AWIIIQIng
Pi'esetTime
8 Gas I Diesel Gas
10 Second 15 Second 20 Second 45 Second
Delay Delay Delay Delay
9
Single" Double Pulse Start
DoublePfHS
SIng!e 'Pre$s
10 IGN 2 Output Ignition 2
Accessory Start
I Crank
11
2 or 3 Hour Start
3 Hour 2 Hour
12 Turbo Timer
OFF
1 Minute
3 Minute 5 Minute
Tach Programming
The unit will not operate unless tach is programmed or tachless option is
turned ON. If an attempt is made to start the vehicle via the remote start without
first programming tach, the unit will flash the parking lights 7 times indicating tach
has not been learned and stored. If the tach rate is not properly programmed to
the specific vehicle, the unit may not realize that the vehicle is running in certain
instances and reengage the starter motor.
The Remote Start unit will learn the tach rate of most vehicle's single coil, mUltiple coil
packs, or single injector. To learn tach:
1. Turn the ignition key to the ON position.
2. Press and release the valet/override button 3 times.
3. Immediately turn the ignition key OFF.
4. Press and hold the valet/override button, then start the vehicle using
the key.
5. When the unit senses the tach signal, the parking lights will begin to
flash.
6. Allow the vehicle to settle to a normal idle speed.
7. Release the valet/program push-button switch. The parking lights will
turn on for 2 seconds indicating that the learned tach signal is stored
and the unit has exited tach learn mode.
2010 Audlovox Electronics Corporation. All rights reserved.
23