Installation guide
Set Up & Programming
Transmitter Programming - Feature Bank 1
1.
Turn
the ignition ON.
2. Press and hold the valet/override button.
3.
Within 10 seconds the system will chirp (3) three times.
4. Press 1 button of each transmitter you wish to program.
5.
The
system will respond with 1 chirp for each accepted transmitter.
6. Pressing the override button
at
anytime during
programming
will
advance
to
the
next
bank.
NOTE:
The
system will exit transmitter programming after 15 seconds of inactivity.
NOTE:
This
system has 1 button programming which
programs
all channels
of
the
system.
NOTE:
The
system will hold up to 4 transmitters in memory, programming a 5th
transmitter
will erase the
oldest
transmitter in memory.
NOTE:
This
system has PTN - Programmed
Transmitter
Notification. Each time the
ignition is
turned
ON, the
LED
will flash the
number
of
transmitters
programmed
to
the system.
Transmitter programming for 2 Car Mode *2 way system only:
1.
Enter
the transmitter into 2
Car
Mode.
(Refer
to transmitter operation in the
owners
manual for 2
car
operation)
2. Follow the steps
above
for transmitter programming.
NOTE: 2
car
mode
requires an additional security system installed
in
a second
vehicle.
Manual Feature Programming - Feature Bank 2 - 4
1.
Turn
the ignition ON.
2.
Press
and hold the valet/override button.
3. Within 10 seconds the system will chirp (3) three times.
4. Use the valet/override button to
advance
through each option bank. For
feature
programming
advance to Feature
Bank
2, 3 or 4, which is (4) four,
(5) five, and (6) six chirps.
5.
Use
the transmitter
()
button to scroll through the selections
in
each
feature bank, the system will chirp to match the feature number.
6. Press the transmitter i button to change the desired feature. The LED will
flash indicating the changed feature.
2010 Audiovox Electronics Corporation. All rights reserved.
21