Specifications

50 Pelco Manual C1920M-D (4/03)
Table F. Operation Guide (continued)
OPERATION MODEL FRONT PANEL COMMAND RESULT
S/D
S/D
D
S
D
S
Open or close a log
of the last 72
alarms.
Display and record
alarms and/or
activity detection.
1. Press the VIEW button twice to
display the alarm list. (If there are
more than 18 alarms logged, use
the up/down arrows to scroll
through the list.)
2. Do one of the following to close the
log.
a. Press the VIEW button twice to
clear the list and close the log.
b. Press any front panel button
(except SEQUENCE) once to
close the log without clearing the
alarm list.
c. Press any camera or the VIEW
button once to close the log
without clearing the alarm list.
Program alarms in the System Setup,
Record Setup, Camera, and Advanced
System Setup menus. Program activity
detection in the System Setup, Camera,
and Advanced System Setup menus.
Same as for duplex command above
with the following addition: Multiplexer
must be in RECORD mode to record
alarms or activity.
Displays or removes alarm list on the
main monitor.
Main, spot, and auxiliary monitors respond
to programming instructions. If there are
multiple alarms/activity detection, monitors
will sequence cameras. Monitors will
return to previous operation about 15
seconds after all activity detection has
stopped or after alarms have timed out.
In alarms/activity mode, any alarm will
take precedence and override the
camera being displayed.
Same as duplex result.