Specifications

Pelco Manual C1920M-D (4/03) 49
Table F. Operation Guide (continued)
OPERATION MODEL FRONT PANEL COMMAND RESULT
D
S
S/D
D
S/D
D
S
D
S
Displays the recorded cameras in the
selected format on the main monitor.
NOTE: Pelco Genex multiplexers can
normally decode tapes made with other
manufacturers’ multiplexers. However,
DM models DM/SPQ4/S/N/090 and
DM/SPC4/D/N/16M must be properly
programmed to create tapes that are
compatible with Genex multiplexers.
(Refer to Tech Tip 00-3038 for pro-
gramming details.) Tapes made with
DM model DM/SPR2AS/C/M/M are
incompatible.
Monitor responds to programming
instructions.
Deactivates the alarm.
Deactivates the alarms.
Deactivates the alarm.
Deactivates the alarm.
Deactivates the alarms.
Deactivates the alarms.
1. Make sure the LIVE/VCR LED on
the left of the front panel is OFF. If
the light is not off, press the LIVE/
VCR button to toggle the light OFF.
1. Make sure the monitor displays
“VCR”. If not, press the DISPLAY/
RECORD button until the monitor
shows VCR mode.
2. Turn on the VCR and press the
PLAY button.
3. Press the button of the camera you
want to view, or press a button
below the 4, 9, or 16 icons for
multiple camera playback.
Program the monitor in the Advanced
System Setup menu.
1. For a single alarm, press the VIEW
button once.
2. For multiple alarms, press the
VIEW button once each time a
camera with an alarm sequences
to the main monitor.
1. For a single alarm, press the VIEW
button twice.
1. For a single alarm, press the VIEW
button once.
2. For multiple alarms, press the
VIEW button twice each time a
camera with an alarm sequences
to the spot monitor.
2. For multiple alarms, press the
VIEW button once each time time a
camera with an alarm sequences
to the spot monitor.
Play a tape.
Call a camera or
run a sequence of
cameras on the
auxiliary monitor.
Deactivate alarm(s)
for camera
displayed on the
main monitor.
Deactivate alarm(s)
for camera
displayed on the
spot monitor.
(Continued on next page)