Specifications

40 Pelco Manual C1920M-D (4/03)
PROGRAMMING THE 9-CAMERA DISPLAYS ( BUTTON)
You can program two groups of nine cameras each (16-channel model only). Both groups
can be programmed to include any nine cameras.
is not available in RECORD mode
for the simplex models.
To program the nine-camera displays:
1. Press the
button to call up a nine-camera display. If necessary, press the
button again to advance to the other nine-camera group.
2. Press the
button for approximately three seconds. A bar will appear in the first
camera location of the nine-camera display, indicating you are in programming mode.
3. Use the arrow buttons to move to each camera location in the nine-camera display.
4. When the camera location you desire is highlighted, choose the new camera by
pressing the camera button for the desired camera.
5. To exit programming mode, press any arrow button as many times as necessary until
the bar moves off the screen.
6. If necessary, repeat steps 1-5 to program the second group.
PROGRAMMING THE 16-CAMERA DISPLAY ( BUTTON)
is not available in RECORD mode for the simplex models.
To program the 16-camera display:
1. Press the button to call up the 16-camera display.
2. Press the button for approximately three seconds. A bar will appear in the first
camera location of the 16-camera display, indicating you are in programming mode.
3. Use the arrow buttons to move to each camera location in the 16-camera display.
4. When the camera location you desire is highlighted, choose the new camera by
pressing the camera button for the desired camera.
5. To exit programming mode, press any arrow button as many times as necessary until
the bar moves off the screen.