Specifications
Pelco Manual C1920M-D (4/03) 39
MULTIPLE CAMERA DISPLAY SETUP
Use the front panel controls to configure multiple camera display formats. LEDs above the
camera buttons illuminate to indicate which cameras are being displayed.
PROGRAMMING THE PICTURE-IN-PICTURE DISPLAY
(
BUTTON)
You can program the on-screen location and size of the picture-in-picture (PIP) display. PIP
is not available in VCR playback mode.
To program the PIP display:
1. Press the
button.
2. Press the
button (for approximately three seconds) until the message PRO-
GRAM PIP SIZE appears.
3. Use the arrow buttons to increase or decrease the PIP display size.
4. Press the +/- button. The message PROGRAM PIP POSITION appears.
5. Use the arrow buttons to move the PIP display location.
6. Press the +/- button to exit the PIP programming menu.
PROGRAMMING THE 4-CAMERA DISPLAYS ( BUTTON)
You can program four groups of four cameras each. Each of the four groups can be
programmed to include any four cameras. is not available in RECORD mode for the
simplex models.
To program the four-camera displays:
1. Press the button to call up a four-camera display. If necessary, press the
button again to advance to the four-camera group you wish to configure.
2. Press the button for approximately three seconds. A bar will appear in the first
camera location of the four-camera display, indicating you are in programming mode.
3. Use the arrow buttons to move to each camera location in the four-camera display.
4. When the camera location you desire is highlighted, choose the new camera by
pressing the camera button for the desired camera.
5. To exit programming mode, press any arrow button as many times as necessary until
the bar moves off the screen.
6. If necessary, repeat steps 1-5 to program another group.
NOTE:
All active cameras
can be sequenced in one
location in 4-, 9-, or 16-
camera display mode. While
in multiple-camera display
mode, use the arrow buttons
to move the on-screen bar
to the camera location for
sequencing. Press the
SEQUENCE button to
initiate sequencing of all
active cameras. Refer to the
Operation Guide
table also.