Specifications

Pelco Manual C1920M-D (4/03) 37

SEQUENCE SETUP (SEQUENCE BUTTON)

GROUP QUAD (2x2)

1 04

2 04

3 04

4 04

NINE (3x3)

Figure 27. Camera Sequence Menu

Sequencing can be programmed in full screen, four-camera and nine-camera displays.

Cameras will not sequence when operating the zoom function. LEDs above the camera

buttons will illuminate to indicate which cameras are being displayed.

To program camera sequencing:

1. Press the SEQUENCE button for approximately three seconds until the Sequence

menu appears. Type the password, if requested. The currently selected menu item

blinks.

2. Use the arrow buttons to move between items on the screen.

3. When the menu item you desire is highlighted (blinking), press the +/- button to cycle

through the options to select the one you want.

4. When you finish all the changes you want to make, go to EXIT.

5. Press the +/- button to exit programming mode.

When HELP is highlighted, you can press the +/- button to display a help screen that tells

you which buttons to press to configure specific options.