Specifications

Pelco Manual C1920M-D (4/03) 25
PASSWORD
You can program the multiplexer to request a password to access programming menus.
Enable the password in the Advanced System Setup menu (refer to the Advanced System
Setup [View Button] section).
The universal password is 3916 and cannot be changed. You must enter this password by
pressing the camera number keys whenever a password is requested.
CHANGING THE LANGUAGE
You can work in any of four languages: English (default), French, German, or Spanish. To
change:
1. If the multiplexer is plugged in, unplug it.
2. Reset the multiplexer to factory defaults by holding down the VIEW button while
plugging in the multiplexer. Continue holding down the button until the Initialization
menu appears.
Any programming you have already done will be lost.
Also, any time you do a reset, the unit defaults to English.
3. A timer at the bottom of the screen begins a countdown. You must select the
language you want before the timer runs out (step 4).
4. Use the number buttons on the front of the multiplexer to highlight the software version
(language) you want: button number 1 = English, 2 = French, 3 = German, 4 = Spanish.
5. Let the timer run out. The language you chose is now active, as are the factory
defaults.
6. Program the multiplexer as desired.
MENUS
SYSTEM SETUP (VIEW BUTTON)
2/6/8 Hr
2/6/8 Hr
MAIN MONITOR VIDEO
RESET ACTIVITY DETECTION ALL CH TO
*2, 6, or 8 Hr 120 Hr
12 Hr 168 Hr
16 Hr 180 Hr
18 Hr 240 Hr
24 Hr 360 Hr
48 Hr 480 Hr
72 Hr 600 Hr
84 Hr 720 Hr
96 Hr 960 Hr
HIGH RESOLUTION
REDUCED FLICKER
MAIN MONITOR DISPLAY HIGH RESOLUTION
**†
* 2/6/8 HR FOR NTSC/EIA MODEL MULTIPLEXERS, 3 HR FOR PAL/CCIR MODELS.
REMAINING RECORD SPEEDS DEPEND UPON VCR MODEL.
** NOT SHOWN ON MONOCHROME MODELS.
† NOT SHOWN ON SIMPLEX MODELS.
**†
Figure 19. Basic System Setup Menu