Operator`s manual

SRT Commands:
Move the mouse pointer to the upper right of the control console and click the button
labeled:
Rcmdfl
Move the mouse pointer down to the command line input box and type the SRT
command filename you wish to open:
Filename.cmd /*example = beamsize.cmd (the suffix .cmd is required)
The software will read the input command file similar to the above example in sequence
and output and ASCII text file that can be processed by a spread sheet such as MS-Excel
or a hand written program to process the data in your particular form.
Output:
Output data will default to a day/time stamp ASCII text file with the filename:
yydddhh.RAD
Where, yy is the year, ddd is the day number (UT) and the hh is the UT hour at
the opening of the output file
The resulting scan plots might look like the plots seen on the next page. These plots are
the output from MS-Excel.
The azimuth-plot horizontal scale reflects the correction of azimuth degrees above the
horizon by the cosine of the elevation angle. The horizontal scale on both plots has been
drawn through the half-power points.