Specifications

be programmed for not longer than 60 seconds.

3. General Control Programming:

• Must be programmed for no swinger shunts (Program Address 0000 data digit 2, enter 0, 1, or 2).

• Program Address 0185 must be programmed as: Data Digit 1=0, Data Digit 2=0.

4. Commercial Fire Mode Programming:

• Local (Program Address 0186, data digit 1, enter as a 1 through 6).

• Central Station (Program Address 0186, data digit 1, enter as a 7 through *2).

• The keypad panic functions are not intended to be a substitute for Listed manual pull boxes.

12.6 Wiring and Programming Information for Installations Using the Ademco AB-12 Bell/Housing

1) Disconnect the wire jumper from terminal 4 to the inner housing of the Bell Box (prevents a ground fault condition).

2) Connect wiring between the control and Bell Box as shown above. To use the AB-12 Bell/Housing, cut the jumper wire “JP1” on the

control. The EOL used in the AB-12 Bell/Housing must be 27K ohms.

3) Program Zone 8 as a 24-hour zone by programming it to follow zone function 7. (Program address 0025 = 07).

4) Do not change the default programming of zone function 7. (Program address 0007 should be 22).

Control/Communicator

Cut this jumper

JP1

o controlAlarm Output +

o controlAlarm Output –

To control Zone 8 Input

To control Loop Positive

To control Earth Ground

EOL

27K

Ω

BELL

Bell Tampers

Outer Bell Box

Inner Bell Box Lining

Ademco AB-12 Bell/Housing

Terminal 1

Terminal 29 (+)

Terminal 30 (8-)

Terminal 5 (-)

Terminal 6 (A)

Alternate EOL (if not

using a Fire card)

Detection Systems’

P/N 28300