Specifications

DS7400Xi Ver. 3+ Reference Guide Copyright © 2004 Detection Systems, Inc. P/N: 28995K Page 42
11.7 Output Partition Assignment: Program Addresses (0149-0150)
In Output Partition Assignment, each On-board output is assigned
to a partition. By default, outputs are assigned to all partitions.
11.8 Partition Control Programming: Program Address (0165)
Partition Control programming defines the number of partitions in use
and the common area (common area can only be partition 1).
See Glossary (section 6.5) for further details.
Data Digit
12
1
2
3
4
5
6
7
0Belongs to Partition 1
Belongs to Partition 2
Belongs to Partition 3
Belongs to Partition 4
Belongs to Partition 5
Belongs to Partition 6
Belongs to Partition 7
Belongs to Partition 8
Select Option DD
8Follows all Partitions
12
Must Be
0
Data Digi
t
0
Alarm
Programmable Output 1
Programmable Output 2
0149-DD1
0149-DD2
0150-DD1
8
8
8
Output Address Default
P
A
0
1
4
9
P
A
0
1
5
0
Example:
To program the Partition Control as: the System will use 3 Partitions,
and Partition 1 is common to Partitions 2 and 3.
Data Digit 1 = [2], Data Digit 2 = [1].
Enter the Programmer’s Mode: [9] [8] [7] [6] [#] [0]
Enter the Program Address: [0] [1] [6] [5]
Enter Data Digit 1: [2]
Enter Data Digit 2: [1]
Enter the pound key: [#]
Program the next Address, Program a different Address, or Exit the
Programmer’s Mode.
1
2
3
4
5
6
0No Common Area
Partition 1 Common to Partition 2 and 3
Select Option
DD
Data Dig
it
12
1
2
3
4
5
6
7
0Use 1 Partition
Use 2 Partitions
Use 3 Partitions
Use 4 Partitions
Use 5 Partitions
Use 6 Partitions
Use 7 Partitions
Use 8 Partitions
Select Option DD
Partition 1 Common to Partition 2 - 4
Partition 1 Common to Partition 2 - 5
Partition 1 Common to Partition 2 - 6
Partition 1 Common to Partition 2 - 7
Partition 1 Common to Partition 2 - 8