Specifications

DS7400Xi Ver. 3+ Reference Guide Copyright © 2004 Detection Systems, Inc. P/N: 28995K Page 25
7.7 Automatic Arming
Each partition can be programmed to automatically arm once per day.
To inform occupants that the system is about to arm, a pre-arming period will begin 15 minutes before the system arms automatically. The
keypad sounders, and any outputs programmed to follow the keypad sounders, will pulse five times every minute if programmed to do so
in Program Address 0202-0205. During the last five minutes before arming, these sounders will be on steady. Once per minute the keypad
will read, “Arm in nn min./PIN + OFF - extend.”
If automatic arming is used in Master Keypad mode, it will affect all partitions you have access to. If used in single partition mode, or from
a single partition keypad, it will affect only the partition you are working in.
To program the Automatic Arming Time, perform the following steps:
Notes
Setting the Automatic Arming Time
Enter a [Master PIN] + [#] + [0]
Setting the Automatic Arming Time can only be
performed in the Master Programming Mode.
Enter a [1]
to enter the Automatic Arm Setup programming
Enter the partition number.
Press [#] to exit.
Enter a time for each day.
Enter in [0] [1] [0] [0] [#] format.
If programming is done from a Master Keypad
that is not in single partition mode, the user wil
l
be prompted to enter the partition they wish to
program.
The user will only be allowed to program the
partitions to which they are assigned. If pro-
gramming from a standard keypad, or from a
Master Keypad in single partition mode, this
step will be skipped.
The display will start with Sunday. It will read,
“Sunday - nn : nn”
Enter the time in 24 hour format then press the
[#] key. If you make a mistake, press the [*] key
twice to move back to your last entry.
Samples of times:
12 midnight = 2400# 12 noon = 1200#
12:01am = 0001# 12:01pm = 1201#
1:00am = 0100# 1:00pm = 1300#
Disabled = 0000#
To extend the Automatic Arming of the system during the automatic arming pre-arming period by 30 minutes from the time of command
entry, enter [PIN] + [OFF]. For a longer delay, perform the following steps:
NotesDelayed Automatic Arming
Enter a PIN
Enter [#] [9] [9]
to enter the Delayed Arming programming
Enter the number of hours from now
that you would like the system to arm.
For example: If it is 3:30 now, and you
would like the system to arm at 9:30,
enter [0] [6] [#].
The keypad will display the following:
Arm in nn Hours
# to accept
Enter the number of hours to delay arming.
Enter using [0] [1] [#] format
To extend the Automatic Arming at any time, use the Delayed Arming feature (see section 7.6).