Instruction manual

Installation
7400 & 7450 Manual
2.1 MOUNTING THE KEYPAD
Prior to starting, select the location where the keypad unit is to be
mounted.
Perform the following steps:
1) Open the keypad by loosening and removing the case security screw
located at the bottom using the security spline key.
2) Depending on the type of installation, gang box or wall mount, drill the
respective holes into the rear cover.
3) Use the provided drilling template to accurately locate and drill the
required holes in the wall or panel.
4) Use the hardware provided to mount the back plate on the wall or
gang box. Route the wiring via the large center hole in the back plate.
Check to make sure the back plate is level.
5) Wire the keypads pre-wired cable as instructed in this manual.
2. Installation
Page 9
A
A
TAMPER
LENS
TAMPER
LENS
A
A
FIGURE 2: DRILLING HOLES IDENTIFICATION

NOTE: THE CENTRAL HOLE IS FOR ROUTING THE WIRING TO THE CONTROLLER