Instruction manual

Programming

7400 & 7450 Manual Page 42

4.14 PIN CODE LENGTH/FACTORY DEFAULT

SETTINGS

Note:

• You must be very careful before using this com-

mand. Changing the PIN Code length will also erase the

ENTIRE memory contents, including all the user and

special codes, and return all codes to the factory default

settings.

Note:

• When choosing the 4-8 option, please note that you

should either enter zeros before the code, or press pound

at the end (for example if your code is 12345, either enter

00012345 or 12345#).

1) Enter the Programming Mode.

2) Select the desired PIN code length

as follows:

A) 00-Returns to factory defaults and sets a 4 digit code.

B) 05-Returns to factory defaults and sets a 5 digit code.

C) 06-Returns to factory defaults and sets a 6 digit code.

D) 08-Returns to factory defaults and sets a 4-8 digit

code.

THE MODE INDICATOR FLASHES RED

THE DOOR INDICATOR FLASHES RED



MODE

DOOR

RED



RED

3) Enter the Programming Code.

IF THE PROGRAMMING CODE IS VALID, ALL

MEMORY WILL BE ERASED. YOU WILL HEAR

3 BEEPS AND THE KEYPAD WILL RETURN TO

NORMAL MODE. IF THE PROGRAMMING CODE

IS INVALID, YOU WILL HEAR A LONG BEEP AND

THE KEYPAD WILL RETURN TO NORMAL MODE,

WITHOUT ERASING THE MEMORY CONTENTS