Instruction manual

Programming

7400 & 7450 Manual Page 32

Note:

• This mode takes control of the Door Indicator LED. The

LED will not be lit when: a valid code is entered or while

in Secure Mode, or when waiting for a Secondary Code.

4.9 SETTING THE LOCK OUT FEATURE

In case the keypad is consecutively presented with invalid codes, the

keypad will go into Lockout Mode. When a lockout occurs, the keypad

becomes locked and no codes can be entered until the Set Lockout

period expires. During lockout, the Mode Indicator LED is off, the Door

IndicatorLEDashesred,andthekeypadbeepseverytwoseconds.

The default setting for the Lockout feature is 4000 (Lockout Disabled).

Note:

• Using the Lockout feature is highly recommended, espe-

cially when selecting to use short PIN Code lengths (4 or

5 digits).

1) Enter the Programming Mode.

GREEN

THE MODE INDICATOR FLASHES GREEN

THE DOOR INDICATOR STAYS GREEN



MODE

2) Depress -6- to enter Menu 6.

GREEN

? ?

3) Construct a code using the

following instructions:

SET THE NUMBER OF INVALID

CODE ATTEMPTS, WHICH WILL

CAUSE LOCKOUT BETWEEN

0 AND 9 ATTEMPTS

SET THE DURATION OF THE

LOCKOUT BETWEEN 00 & 99.

THE VALUE IS MULTIPLIED

BY 10, RESULTING IN

0 TO 990 SECONDS.

4) System returns to Normal Mode.

YOU WILL HEAR 3 BEEPS

THE MODE INDICATOR TURNS GREEN

THE DOOR INDICATOR TURNS OFF

GREEN

MODE

DOOR