Troubleshooting guide

1336 PLUS - 6.16 - September, 2001
4-2 Disassembly and Access Procedures
Tools
You need the following tools to disassemble and assemble the drive:
• Pliers
• #2 Phillips and a magnetic flat blade screwdriver
• 5/16 - inch or 8mm socket.
• Torque wrench, metered in lb-in. or N-m
Disassembly and Access
Procedures
Drive Enclosure Removal & Installation
!
ATTENTION:
Disconnect and lock out power from the drive
before disassembling the drive. Failure to disconnect power may
result in death or serious injury. Verify bus voltage by measuring
the voltage between +DC and -DC on Terminal Block TB1. Do
not attempt to service the drive until the bus voltage has
discharged to zero volts.
!
ATTENTION:
Wear a wrist type grounding strap when
servicing 1336 PLUS II Drives. Failure to protect drive
components against ESD may damage drive components. Refer
to Electrostatic Discharge Precautions at the beginning of this
chapter.