Technical data

If a reduction of capacity is necessary because of insufficient stability of the
complete unit, new capacity plates must be fixed giving the derated capacity in
accordance with the final stability test.
(!) ATTENTION (!)
Always check carefully that the vehicle is perfectly stable, paying special atten-
tion to the area immediately in front of the driver’s cabin as this is usually less
stable.
16.7 In the case of the appearance of the signal “ALARM”
on the display of the control panel or of the radioremote
control
or in case of an electrical failure.
In these cases, because of a fault, shown in the system, the crane is not func-
tional any more. The checks that the operator can effect to reactivate the crane
functions are the following:
- in case of an electrical failure check the connection of the feeding cables to
the battery;
- in case of the appearance of the signal “ALARM” on the display of the push-
button panel see Par. 15.7.1 and check if the fault can be resolved by the
operator.
If the fault cannot be resolved, you must immediately go to a FASSI autho-
rised Center after bringing the crane to its the rest position in relation to the
conditions explained in the paragraphes 15.7.2, 15.7.3.
16.7.1 Diagnostic (Alarms/Input/Output) LME vers. 4-5 UC 01-7
It is possible to install on the machine some operation improvements of the
limiting device not yet described here. For this purpose compare the released
version of the software installed on the machine (you can read it on the display
when switching on) with the one in this paragraph's heading. For further expla-
nations please refer to Fassi service network.
All the eventual problems that the electronic device can have are shown on the
display of the control panel and they create the stop of all crane functions. The
visualisation of the alarm must be reset pushing the button l.m.l.d. exclusion on
the main box control panel, which bring again the display in the original screen
showing the pressures only if the problem has been solved. As consequen-
ce of this, when appear an alarm signal it is necessary to solve the problem
because only in this case will be possible to reset the display and reactivate
the crane working.
16.7
CONTROLS TO
OPERATE THE CRANE
GRU FASSI