Technical data

The instruction plate DE5643 reported on the selector, identifies the interven-
tion sectors of the device (fig. 16).
The operator's presence in the stand-up control station allows only a reduced
rotation of the crane, since it is not enabled to pass on the station.
When the operator is not present in the stand-up control station, the crane is
allowed to operate at its max rotation arc (which may differ from 180° indicated
on plate DE5643). In case the operator is not in the stand-up control station
and the rotation arc at the beginning reaches the position above the station, a
red light starts flashing and a buzzer starts ringing until the aforesaid rotation
arc is maintained.
If you operate from the crane dual controls (maximum rotation arc allowed),
take extreme care when lowering the inner boom or while rotating the crane
near the stand-up control station, in order to prevent the crane booms from
clashing against the structure of the stand-up control station.
The column is fitted with a device that informs the driver through a sound/light
signal in the cab, that the inner boom max position allowed during lifting has
been exceeded.
14.7
CONTROLS TO
OPERATE THE CRANE
GR2_60»65_3_4
fig. 16
fig. 16b