Instruction manual

38
Viewing and Setting the Viewfinder Display
Chapter 3 Basic Adjustments and Settings
3-7-3 Setting the Voltage Warning
Values
The Near End and End values used to issue battery voltage
warnings when the supply voltage drops are set on the
<Battery Alarm> page in the Config menu.
Two Near End and End values can be saved, and you can
switch between them as required.
<Battery Alarm> page
3-7-4 Magnifying the Viewfinder
Display
The image displayed in the viewfinder can be magnified by
assigning the Mag function to an ASSIGN button. The
magnification changes between 2-times, 4-times, and Off
each time the ASSIGN button is pressed.
The position of the magnified image displayed in the
viewfinder can be adjusted by assigning the Mag Position
function to another ASSIGN button. The position of the
magnified image moves one step from top left to bottom
right each time the ASSIGN button is pressed.
• The magnified display returns to normal 30 seconds after
pressing the ASSIGN button. Also, the display returns to
normal when power is applied and when recording starts.
• If the image is magnified by 4 when using the
Anamorphic Unsqueeze x2 function, the image is
magnified in the vertical dimension by 4, but the
horizontal dimension remains magnified by 2.
When the image is magnified, the following information is
displayed in the viewfinder.
a Magnification
When the image is magnified by 2, “Mag x 2” is displayed;
when magnified by 4, “Mag x 4” is displayed.
b Magnification position
Displays the position of the magnified image.
Item Setting
DC IN (24V) Type Selects the 24 V system supply settings.
You can set Near End and End
threshold values for both Type1 and
Type2.
Near End Sets the 24 V power supply Near End
value (20.5 V to 30.0 V). The default is
22.2 V.
End Sets the 24 V power supply End value
(20.0 V to 24.0 V). The default is 21.6 V.
DC IN (12V) Type Selects the 12 V system supply settings.
You can set Near End and End
threshold values for both Type1 and
Type2.
Near End Sets the 12 V power supply Near End
value (11.0 V to 17.0 V). The default is
11.1 V.
End Sets the 12 V power supply End value
(10.5 V to 14.0 V). The default is 10.8 V.
Notes
12