Specifications
2
Diagnostic Devices
6
REVISION LEVEL A - 12/09/13
PLEASE NOTE!
2. DIGI-DIAGNOSTIC TOOL / FAULT CODE READER
Both of these units will provide quick access to the checking and clearing
of fault codes but only Edith will provide true diagnostics capability. As such
these units are shown for reference only.
Figure 3
SPECIAL TOOLS AND ADAPTORS
1. Depending on the heater model and application, diagnostic adapters
may be required to interface with the heater harness and perform
functions.
2.
If the heater does not operate (no fan or circulating pump), verifying
there is output on the yellow wire is imperative. This can be done by
inserting the proper following adapter in the harness at the heater and
using a DVM to validate power on the yellow when the control device is
requesting heat. This should be close to battery voltage. If there is battery
voltage found connect diagnostic device (gure 3) and conrm fault
code.
Figure 4
Standard, MaxxPower and ParkSmart Gen 5 Espar diagnostic interface
adapter. Part number: 20 2900 70 50 28
Figure 5
ParkSmart Gen 1,2 & 3 Espar diagnostic interface adapter.
Part number: 25 2786 07 00 01